Ch half cut setting, Half cut setting – Brother PT-9700PC User Manual
Page 41
Advertising
15
^CH Half
cut
setting
[ASCII] ^ C H n
[Decimal]
94 67 72 nd
[Hexadecimal]
5E 43 48 nh
[Parameters]
0≤n≤1
[Description]
・
Specifies whether or not half cut is used.
n:
Half cut setting
(ON: 1 (default); OFF: 0)
・
This command is a dynamic command.
[Remarks]
・
Invalid if n is a value other than 1 or 0
[Example]
・
To make half cuts:
Since half cuts will be enabled, n=1. Therefore, the command will be as follows.
^ C H 1
(5Eh 43h 48h 31h)
Advertising
This manual is related to the following products: