Brother PT-9700PC - Manual (Page 44)

18
^SP Special tape setting
[ASCII] ^ S P n
[Decimal] 94 83 80 nd
[Hexadecimal] 5E 53 50 nh
[Parameters] 0≤n≤1
[Description]
・ Specifies whether or not the special tape setting is enabled.
When the special tape setting is ON, the cut settings and chain printing setting are not
available (same as being OFF). When the special tape setting is OFF, the cut settings and
chain printing setting are applied as specified.
n: Special tape setting
(OFF: 0 (default); ON: 1)
・ This command is a dynamic command.
[Remarks]
・ Invalid if n is a value other than 1 or 0
[Example]
・ To use the special tape setting:
Since the special tape setting will be enabled, n=1. Therefore, the command will be as
follows.
^ S P 1
(5Eh 53h 50h 31h)