HP Latex 3000 Printer - Manual (Page 120)

7. Slide the new roll onto the upper axle.
8. Insert the upper axle, placing the end cap on the side, and slide it all together until you hear a click.
9. Pass the leading edge of the roll over the upper rollers, and thread the cleaning material through the
rollers on the left.
10. There is a strip of polyester film on the leading edge of the cleaning material. Insert it into the hole in
the takeup core, which takes hold of it.
11. Slide the takeup core onto the lower axle.
NOTE: If the cleaner roll has not been properly installed, you may see a message about clearing a
printhead cleaning roll jam. Pull the whole assembly out, wind a little of the roll forward, then slide it
back in again. The printer will check the roll again
12. Restore the pinch system by moving the black knob back into place. If you feel resistance because the
cleaning roll is too tight, turn the roll slightly counter-clockwise.
TIP: There is a green ring on the far side of the black knob, which should not be visible if the knob has
been correctly placed. If it is visible, try again.
114 Chapter 5 Handle the ink system ENWW