HP Latex 3000 Printer - Manual (Page 90)

This method will automatically cut your image into sections and print the sections separately. There are two
alternative ways to select the size of the sections:
● Select the width and height of each section. The number of sections is then calculated automatically.
● Select the number of horizontal and vertical sections. The width and height of each section is then
calculated automatically.
If you choose a non-zero overlap, the size of each section will be increased by that amount so that the
printed sections will overlap when put together.
If you have requested multiple copies, you can specify the vertical gap between copies.
The drop-down list at the top of the preview field allows you to choose all sections or just one of the sections
to be printed.
Double-sided
Double-sided printing helps you to print rows of images on both sides of the substrate.
● There is a process to guide you when printing a substrate on both sides.
● Double-sided printing can be used to print the same image or different images on each side.
● The process automatically compensates for any registration errors, of the position of the plot, along
both axes (along the substrate width + substrate advance) to minimize any errors.
● Neither the dual-roll spindle nor the ink collector kit can be used when printing double-sided.
● The images of Side A and Side B must have approximately the same dimensions. The image that you
select for each side must be the same image for the entire side.
Create a job
Any image created in the RIP can be printed in either side A or side B, without any special requirements.
However, side A and side B must have the same dimensions when printed on the substrate.
84 Chapter 4 Create and manage print jobs ENWW