HP Latex 3000 Printer User Manual
Page 285
To confirm it, go to the Internal Print Server and select Printer > Advance Calibration to check the
substrate advance. See
Substrate-advance test print on page 129
To correct the substrate advance, see
Substrate-advance compensation on page 128
this will solve the problem. However, you are recommended to run the OMAS Diagnostic Tests from the
Print Care window as soon as the substrate is unloaded, to avoid having the same problem with other
substrates. See
Clean the substrate-advance sensor on page 202
If the problem persists, try adjusting tension and vacuum settings according to the table below, step by
step (a to c), until you find settings that work.
●
Printhead-to-ribs spacing. Check the printhead-to-ribs spacing in the Internal Print Server. If it is
higher than normal, try reducing it.
ENWW
Advanced print-quality troubleshooting 279