HP Latex 3000 Printer - Manual (Page 67)

Load a roll (roll-to-collector configuration)
This configuration is similar to the roll-to-free-fall configuration, but with the addition of a collector roller
and loop shaper.
TIP: Do not try to load or unload the collector while printing.
Before starting to load the substrate, select a loop shaper of the correct length to match the substrate width.
The following tubes are supplied so that you can make up loop shapers of many different lengths.
● One 152-mm (6-in) tube
● Two 203-mm (8-in) tubes
● One 305-mm (12-in) tube
● One 610-mm (24-in) tube
● Two 1067-mm (42-in) tubes
● Two end flanges, to be placed at each end to avoid lateral displacement of the loop shaper during
printing
For example, you can make up the following loop shapers.
● 914 mm (36 in): 610-mm (24-in) and 305-mm (12-in) tubes
● 1016 mm (40 in): 610-mm (24-in) and two 203-mm (8-in) tubes
● 1270 mm (50 in): 1067-mm (42-in) and 203-mm (8-in) tubes
● 1372 mm (54 in): 1067-mm (42-in) and 305-mm (12-in) tubes
ENWW Load a roll into the printer 61