HP StorageWorks XP Remote Web Console Software - Manual (Page 97)

LUN Configuration and Security Manager XP user guide for the XP12000/XP10000/SVS200 97
6. Click Apply. A confirmation message appears.
7. Click OK. Changes in the security settings are applied to the array.
Disabling LUN security
CAUTION: Do not disable LUN security on ports when host I/O is in progress.
1. Start LUN Manager. The LUN Manager pane ( Figure 14 or Figure 15 ) appears.
2. In the tree, locate the port.
3. See the text to the right of the port name to find the LUN security status.
• If LUN security is disabled, you do not need to perform the remaining steps.
• If LUN security is enabled, go to
step 4 .
4. Right-click the port, and select LUN Security: Enable -> Disable. A confirmation message appears.
5. Click YES. The key is removed from the port icon.
6. Click Apply. A confirmation message appears.
7. Click OK. Changes in the security settings are applied to the array.
NOTE: If LUN security is disabled on a port, host groups corresponding to that port are grayed out in the
tree (except for host group 0).
Configuring arrays for using RAID Manager XP commands
The system administrator can enter RAID Manager XP commands from open-system hosts to perform
Continuous Access XP and Business Copy XP operations on logical devices. For example, use RAID
Manager XP commands to create and split pairs. To enable the system administrator to enter RAID
Manager XP commands from open-system hosts, you must specify at least one logical device as the
command device. If desired, you must also apply command device security to other logical devices in the
array.
NOTE: If an array is divided into SLPRs and you want to prevent RAID Manager XP commands from
affecting multiple SLPRs, you must apply command device security to the logical volumes.
Specifying logical devices as command devices
To enable the system administrator to execute RAID Manager XP commands from an open-system host,
you must select at least one logical device that will not be manipulated by Continuous Access XP or
Business Copy XP, and then specify the devices as the command devices. When a RAID Manager XP
command is issued from a host, the command device receives the command. The command device
transfers the command to another logical device. Then, the command performs a Continuous Access XP or
Business Copy XP operation on that logical device.
1. Start LUN Manager. The LUN Manager pane ( Figure 14 or Figure 15 ) appears.
2. In the LU Path or LDEV table, right-click the logical device.
NOTE:
• If nothing appears in the LU Path table, select a host group in the tree.
• The and icons indicate command devices.
• The icon does not indicate any logical device.
3. Select Command Device: Disable->Enable. A confirmation message appears.
4. Click Yes.