HP Tape Library Interface Manager Software - Manual (Page 43)

Chapter 3 Management Operations 43
Chapter 3
Note Take note of the settings in the table shown on the screen above
the Fibre Channel Address Configuration menu. If these are not
acceptable, you may choose to edit them one at a time, or you
may use Hewlett-Packard’s recommended settings.
Hard Addressing
To use the recommended hard address settings:
Caution Re-starting an interface card will stop any data flowing through
that interface card, so any backup in progress will fail.
1. Select [3] from the Fibre Channel Address Configuration menu to place
the recommended values into Pending Settings.
2. Select [4] to Apply those pending settings to all of the Fibre Channel
interface cards. Only the interface cards marked as Restart will have those
settings take effect immediately.
Figure 5 HP’s Recommended Hard Addresses
Address Slot Number
0x33 3
0x34 4
0x35 5
0x36 6
0x47 7
0x88 8
0xA9 9
0xBA 10
0xCB 11
0xCC 12
0xCD 13