HP Tape Library Interface Manager Software - Manual (Page 60)

60 Management Operations Chapter 3
Not Using DHCP
If DHCP is not going to be used:
1. Select [Specify network parameters manually] button.
2. You can now enter the <IP address> desired in the IP address field.
3. In the Subnet Mask field, enter the <Subnet Mask> desired.
4. In the Gateway Address field, enter the <Gateway Address> desired.
5. Select
the [Apply] button to load the configuration into the RMC.
Changing the Fibre Channel Address Modes Using the Web
Administrator
Note An administrator’s password is required before any changes can
be submitted.
To change the Fibre Channel address modes using the Web Administrator, do
the following (see Figure 11 on page 61):
1. Access the Web Administrator as described in Making Changes via the
Web Interface on page 56.
2. Select the [Configuration] tab.
3. Select the [Fibre Channel] button.