HP Tape Library Interface Manager Software - Manual (Page 47)

Chapter 3 Management Operations 47
Chapter 3
Placing a Fibre Channel Interface Card On-Line Using Telnet
To replace a Fibre Channel interface card with a new one, do the following:
1. BEFORE installing the interface card into the Interface Manager, attach the
SCSI cable that was removed from the old card, to the correct bus on the
new card based on the connections printed on the cable label.
2. Insert the new FC interface card into the slot where the old card was
removed. Gently push the card into the slot by placing pressure on the top
AND bottom of the card until it is flush with the chassis. (Pushing the card
in from the top OR bottom alone may damage the card or Interface
Manager (see Figure 7 ).
Figure 7 Installing a Fibre Channel Interface Card into the Interface Manager
3. Log into the IM via a Telnet session as described in Accessing Telnet on
page 38.
4. Select [3] from the Main menu.