HP Tape Library Interface Manager Software - Manual (Page 55)

Chapter 3 Management Operations 55
Chapter 3
Accessing the Web Based Administrator
To access the web based administrator, do the following:
1. Connect a 10 BaseT or 100 BaseT Ethernet cable to the back of the IM.
2. Apply power to connected SCSI and Fibre Channel devices.
3. After all the devices have gone through their power-up routines, boot up
the IM.
4. Power-on the host computer.
5. If you know the IP address for the IM, open the host computer’s Web
browser and enter the IP address into the address field of the Web
browser.
If you do not know the IP address of the IM (or need to change the IP
address), connect to the IM using the RS-232 (serial) connection. Current
information can be seen and changed from the Network Access
Configuration menu.
Note To access the web based administrator, the IM must be assigned
an IP address.
For remote access from WAN or Internet locations, the IP
address must be changed to a valid IP address. Valid IP
addresses have the form x.x.x.x. where each x is an integer in
the range of 0 to 255.
6. When changing an item, the user will be prompted to provide a
password. This information is required each time a change is made.