HP Tape Library Interface Manager Software - Manual (Page 71)

Chapter 3 Management Operations 71
Chapter 3
— If the slot into which you installed the interface card is described as Off-
Line, then you will need to place the interface card On-Line. To do that
refer to Placing a Fibre Channel Interface Card On-Line Using the Web
Administrator on page 67.
11. Using the Web interface, confirm that the drives are detected by the FC
interface card. To refresh the table shown under the Interface Card menu,
select [Enter].
12. Once the interface card is ready to be configured, you may need to set its
addressing mode as described in Changing the Fibre Channel Address
Modes Using the Web Administrator on page 60
13. Plug in the fibre cable.
14. Using the Web interface, check that the card has an appropriate FC
connection and address. To refresh the table shown under the Interface
Card menu, select [Enter]. The table above the Interface Card menu will
show the interface card’s fibre connection status when the interface card is
available to be configured.