HP NetRAID 1Si Controller - Manual (Page 12)

Chapter 1 Overview of HP NetRAID Utilities
6
HP NetRAID Config
HP NetRAID Config is a character-based, non-GUI utility that runs under all
supported operating systems other than Microsoft Windows NT and
Windows 2000. HP NetRAID Config allows you to reconfigure and manage your
HP NetRAID subsystem and to monitor its status.
HP NetRAID Config performs most of the same functions as HP NetRAID
Assistant as well as some additional ones, but it runs under Novell NetWare,
IBM OS/2, SCO OpenServer, and SCO UnixWare.
The command you use to start the HP NetRAID Config utility depends on which
NOS you are using.
•
For Novell Netware, type load megamgr
•
For IBM OS/2, type megaconf
•
For SCO OpenServer, type megamgr
•
For SCO UnixWare, type megamgr
For instructions on using this utility, see Chapter 3, "HP NetRAID Config," in this
guide.