HP NetRAID 1Si Controller - Manual (Page 64)

Chapter 3 HP NetRAID Config
58
configuration information is not disturbed. For instructions on using this
selection, see "Using Easy Configuration" in this chapter.
•
New Configuration also lets you create arrays and hot spares, but this
selection lets you configure spanned arrays. If you select New
Configuration, the existing configuration information on the selected
adapter is destroyed when the new configuration is saved. For instructions
on using this selection, see "Using New Configuration" in this chapter.
•
View/Add/Delete Configuration lets you view an existing configuration
or configure new arrays. This selection does not disturb existing
configuration information. It does not allow you to delete configuration
information. For instructions on using this selection, see "Using View/Add
Configuration" in this chapter.
•
Clear Configuration deletes the existing configuration.
Using Auto Configuration
Auto Configuration creates a configuration by following these steps:
1. Gathers drives with the same capacity into groups of five, four, or three.
These groups become arrays with RAID level 5 logical drives.
2. Gathers pairs of drives with the same capacity together. These pairs
become arrays with RAID 1 logical drives.
3. Configures any remaining single disk drives as arrays with RAID 0 logical
drives.
Auto Configuration does not create any hot spares. If you want to configure hot
spares, use the Easy Configuration or New Configuration selections.