HP NetRAID 1Si Controller - Manual (Page 60)

Chapter 3 HP NetRAID Config
54
Physical Drive
Choose this option to select a physical device and to perform the operations listed
below. When you choose this option, a selection menu is displayed showing the
physical drives in the HP NetServer. Move the cursor to the desired disk drive and
press Enter. The following menu options become available:
•
Rebuild: Choose this option to rebuild the selected disk drive.
•
Format: Choose this option to low-level format the selected hard disk
drive.
•
Make Online: Choose this option to change the status of a Failed drive
back to Online.
•
Fail Drive: Choose this option to change the state of the selected disk
drive to Fail. Changing a drive to the status of Fail also changes the status
of the logical drive in these ways:
◊ Optimal logical drives of RAID level 1, 3, 5, 10, 30, or 50 change to
Degraded.
◊ Degraded logical drives of RAID level 1, 3, 5, 10, 30, or 50 change to
Offline.
◊ Optimal logical drives of RAID level 0 change to Offline.
•
Make Hot Spare: Choose this option to designate the selected disk drive
as a hot spare.
•
Properties: Displays the following properties of the selected physical
drive: Device Type, Capacity, Vendor ID, Product ID, Revision, SCSI
Standard, Queue Tags, predictive failures, and device errors.
•
View Rebuild Progress: Displays the Rebuild progress.
SCSI Channel
Choose this option to select a SCSI channel on the currently selected adapter. You
can perform the following operations on the selected channel.
•
Deactivate Channel: Deactivates the selected channel.
•
Activate Channel: Activates the selected channel. Be sure that TermPWR
is provided for all active channels.
•
Terminate High 8 Bits: Enables termination on the selected channel for
the upper eight bits and disables termination on the adapter for the lower