HP NetRAID 1Si Controller - Manual (Page 51)

Chapter 2 HP NetRAID Assistant
45
2. HP NetRAID Registration Server: Start it before the others by
double-clicking on its Windows icon or by loading NetWare module
reg_serv.nlm .
3. HP NetRAID Access Service: Start it by double-clicking on its Windows
icon or by loading NetWare module raidserv.nlm .
NOTE To change the password for a server using Windows NT or
Windows 2000, run
setpass.exe under
\netraid\dll\ .
To change the password for a server using NetWare, reinstall
the HP NetRAID management software, as described in the
HP NetRAID Series Installation and Configuration Guide or in
the HP NetServer Integrated NetRAID Controller
Configuration Guide, with the new password.
Start HP NetRAID Assistant
Run HP NetRAID Assistant from a client or server in which the HP NetRAID
Assistant utility was installed.
•
To start HP NetRAID Assistant under Windows 95 or 98, click the
NetRAID Assistant icon in the NetRAID program group (or group you
specified).
•
To start HP NetRAID Assistant under Windows NT or Windows 2000,
click the Start button, point to Programs, point to NetRAID in the
Programs menu, and click NetRAID Assistant.
If HP NetRAID Assistant is started on a standalone server, the main window
(shown in Figures 2-1 and 2-3) is displayed immediately.
If HP NetRAID Assistant is started on a client or server that can access integrated
HP NetRAID controllers (or HP NetRAID Series adapters) over the network, you
must select the server you want to access. The HP NetRAID Assistant Main
window has a Server pull-down list next to the Adapter pull-down list.
When you select a server from the server selector box on HP NetRAID Assistant,
a window appears with the choice of access modes: Full Access and View Only.
Select one.
•
Full Access mode requires that authorized users enter a password. The
password is case-sensitive. The password must be given before full access
can be established to a server, and each server can require a unique