HP XP7 Storage - Manual (Page 154)

Cause of error RAID Manager command SSB2
You cannot create the FS pair because you have specified a THP V-VOL in the
initialization process as the FS P-VOL. paircreate 97A4
The command ended abnormally because you specified a volume that was
undergoing online data migration as the FS P-VOL. All commands 97A5
The command ended abnormally because you specified a volume that was
undergoing online data migration as the FS S-VOL. All commands 97A6
You cannot create the pair and use the specified consistency group because
you have you have reached the maximum number of the consistency groups that
can be created. paircreate 97B4
You cannot create the FS pair for the specified P-VOL because the maximum
number of snapshot ID (MU number) was used. paircreate 97B5
You cannot create the FS pair because of one of the following reasons: paircreate 97B6
•
You were in the process of creating a new snapshot group but you reached
the maximum number of snapshot groups that can be created.
• You have specified a snapshot group which has reached the maximum number
of pairs allowed in a group.
You cannot create the FS pair because the THP pool is being initialized. paircreate 97B7
The command ended abnormally because the status of the pairs using the P-VOL
you specified is suspended (“PSUE” status). paircreate, pairsplit,
pairresync, pairresync
-restore 97B9
You cannot create the FS pair from the consistency group to which the specified
snapshot group belongs because of one of the following reasons: paircreate 97BF
•
BC is using the specified consistency group.
•
You have reached the maximum number of pairs that can be created for a
consistency group.
•
A pair that uses the same P-VOL exists already in the specified snapshot
group.
The command ended abnormally because you specified an MU number outside
the allowable range. All commands 97C2
The command ended abnormally because of one of the following reasons: All commands 97C4
• You have specified a pool that is not an FS pool.
•
You have specified a pool that does not exist.
The command ended abnormally because FS is not installed. paircreate, pairsplit,
pairresync, or pairresync
-restore 97C6
You cannot create the FS pair because the capacity of cache management
devices is insufficient. paircreate 97C7
You cannot create the FS pair because the capacity of the volume you specified
as the P-VOL or the S-VOL of the FS pair is more than the supported size (4TB). paircreate 97C8
The command ended abnormally because you specified a pool that is not an
FS pool. All commands 97CB
You cannot create the FS pair because an FS group is already using the CG
number you specified. paircreate 97CF
The command ended abnormally because you are in the process of turning off
the power. All commands 97D4
You cannot run the command because even though the specified serial number
matches the virtual storage machine, the physical storage system's serial number All commands 97D5
that corresponds with the virtual storage machine's serial number does not match
154 RAID Manager command reference