HP SAN Virtualization Services Platform - Manual (Page 44)

reset debug level [module]
Keyword values
[module]
Kernel module that will specifically have its debug level reset. If no value is specified (reset debug),
then all debug levels for all modules are reset.
See also
“ Create debug command ” on page 18
“ Load debug command ” on page 34
“ Save debug command ” on page 46
“ Set debug command ” on page 46
“ Show debug command ” on page 51
Reset port
command
Shuts down the port and then restarts it, leaving the properties of the port unchanged. Use this command
to clear a port that is in an unknown state and trigger the discovery process.
CAUTION:
Running this command disrupts any traffic on this port, and should never be performed on a port that
is moving data. Doing so could cause read/write failure and error conditions in software if traffic
has occurred.
Syntax
reset port
[port number]
*
Keyword values
[port number]
Port number is an integer 0–15 for the DPM to indicate the Fibre Channel port.
* indicates all Fibre Channel ports.
See also
“ Modify ports command ” on page 39
“ Show port command ” on page 59
“ Show ports command ” on page 60
CLI commands 44