HP SAN Virtualization Services Platform - Manual (Page 48)

Syntax
set eth [interface name] link [auto | duplex <duplex value> | speed <link
speed>]
or
set eth [interface name] [family] [method]
Keywords and values
Description of keywords:
[interface name]
Ethernet interface that you are changing: MGMT, GE1, GE2, or GE3.
link [auto]
Auto negotiate duplex and link speed
link [duplex <duplex value>]
Full or half
link [speed <link speed>]
10, 100, or 1000.
family
IPv4, IPv6
method
Address resolution method—auto or manual
See also
“ Disable eth command ” on page 22
“ Enable eth command ” on page 27
“ Modify eth command ” on page 36
“ Show eth command ” on page 54
“ Show eths command ” on page 55
Show bootset
command
Displays the platform, version, status, checksum, and active status of the bootset specified.
Syntax
show bootset [number]
Keyword values
[number]
Number of the bootset (1 or 2).
CLI commands 48