HP SAN Virtualization Services Platform - Manual (Page 61)

10 NO-SIGNAL TARG FABRIC/UNSET NEG/UND 2048
11 NO-SIGNAL INIT FABRIC/UNSET NEG/UND 2048
12 NO-SIGNAL TARG FABRIC/UNSET NEG/UND 2048
13 NO-SIGNAL INIT FABRIC/UNSET NEG/UND 2048
14 NO-SIGNAL TARG FABRIC/UNSET NEG/UND 2048
15 NO-SIGNAL INIT FABRIC/UNSET NEG/UND 2048
See also
“ Disable port command ” on page 24
“ Enable port command ” on page 29
“ Modify port command ” on page 38
“ Modify ports command ” on page 39
“ Reset port command ” on page 44
“ Show port command ” on page 59
Show ps
command
Returns the status (Error or OK) and voltage information for the specified power supply. The DPM
arrives with two power supplies already installed.
Syntax
show ps
[power supply number]
*
Keyword values
[power supply number]
1 or 2.
* indicates both power supplies.
Notes
When looking at the fan side of the DPM, power supply 1 is on the right side, and power supply 2
is on the left side.
See also
“ Show pss command ” on page 61
Show pss
command
Returns the status (Error or OK) and voltage information for each of the two power supplies on the
DPM.
HP StorageWorks SAN Virtualization Services Platform Data Path Module User Guide 61