Error messages appear, Solve scan problems, Scanner did nothing – HP Officejet J3680 All-in-One Printer User Manual
Page 130: Scan takes too long
•
Large, black typefaces look splotchy (not smooth)
The default enhancement setting might not be suitable for the job. Check the setting
and change it to enhance text or photographs, if needed. For more information, see
.
•
Horizontal grainy or white bands in light-gray to medium-gray areas
The default enhancement setting might not be suitable for the job. Check the setting
and change it to enhance text or photographs, if needed. For more information, see
.
Error messages appear
“Reload document and then reload job”
Press the OK button, and then reload the remaining documents (up to 20 pages) in the
ADF. For more information see
.
Solve scan problems
If the following topics do not help, see
for information about HP
support.
NOTE:
If you are starting the scan from a computer, see the onscreen software Help
for troubleshooting information.
Scanner did nothing
•
Check the original
Make sure that the original is loaded correctly. For more information, see
•
Check the device
The device might be coming out of PowerSave mode after a period of inactivity, which
delays processing a short while. Wait until the device reaches the READY state.
Scan takes too long
•
Check the settings
•
If you set the resolution too high, the scan job takes longer and results in larger
files. To obtain good results when scanning or copying, do not use a resolution
that is higher than needed. You can lower the resolution to scan more quickly.
•
If you acquire an image through TWAIN, you can change the settings so that the
original scans in black and white. See the onscreen Help for the TWAIN program
for information.
•
Check the status of the device
If you sent a print or copy job before you tried to scan, the scan starts if the scanner
is not busy. However, the printing and scanning processes share memory, which
means that the scan might be slower.
Chapter 8
126
Maintain and troubleshoot