HP Officejet J5740 All-in-One Printer - Manual (Page 21)

4 Finish setting up the HP All-in-
One
After you have completed the steps in your Setup Poster, refer to this section to help you
finish setting up the HP All-in-One. This section contains important setup-related
information for your device, including information on setting preferences.
This section contains the following topics:
• Set your preferences
• Fax setup
Set your preferences
You can change the settings on the HP All-in-One so that it behaves according to your
preference. For example, you can set general device preferences, such as the language
used to display messages and the date and time on the display. You can also restore the
device settings to what they were when you purchased your device. This will erase any
new defaults you have set.
This section contains the following topics:
• General preferences
• Fax preferences
General preferences
Before you begin using the HP All-in-One, you should review and, if necessary, adjust
the general device settings described in this section.
This section contains the following topics:
• Set your language and country/region
• Set the date and time
• Set the scroll speed
• Set the prompt delay time
• Restore the factory defaults
Set your language and country/region
The language and country/region setting determines which language the HP All-in-One
uses to show messages on the display. Usually, you set the language and country/region
when you first set up the HP All-in-One. However, you can change the setting at any time
by using the following procedure.
To set your language and country/region
1. Press Setup.
2. Press 7, and then press 1.
This selects Preferences and then selects Set Language & Country/Region.
Finish setting up the HP All-in-One 19