HP Officejet J5740 All-in-One Printer - Manual (Page 78)

NOTE: The settings you specify here are only saved on the HP All-in-One. They do
not adjust the settings in the software. You can save your most frequently used
settings by using the software that you installed with the HP All-in-One.
Make a 10 x 15 cm (4 x 6 inch) borderless copy of a photo
For the best quality when copying a photo, load photo paper in the input tray and change
your copy settings for the correct paper type and photo enhancement. You might also
want to use the photo print cartridge for superior print quality. With the tri-color and photo
print cartridges installed, you have a six-ink system.
To make a borderless copy of a photo from the control panel
1. Load 10 x 15 cm (4 x 6 inch) photo paper in the input tray.
2. Load your original photo print side down on the right front corner of the glass.
Position the photo on the glass so the long edge of the photo is along the front edge
of the glass, as indicated by the engraved guides along the edge of the glass.
3. Press Start Copy Black or Start Copy Color.
The HP All-in-One makes a 10 x 15 cm (4 x 6 inch) borderless copy of your original
photo.
NOTE: If you loaded tabbed paper in the photo tray, you can remove the tab
from the copy of your photo once the ink has completely dried.
TIP: If the output is not borderless set the paper type to Premium Photo, and
then try making the copy again.
Related topics
• Load 10 x 15 cm (4 x 6 inch) photo paper
• Set the copy paper type
• Use a photo print cartridge
Chapter 8
76 Use the copy features