Select your fax setup case – HP Officejet J5740 All-in-One Printer User Manual

Page 29

Advertising

Select your fax setup case

Now that you have answered all the questions about the equipment and services that
share the phone line with the HP All-in-One, you are ready to choose the best setup case
for your home or office.
From the first column in the following table, choose the combination of equipment and
services applicable to your home or office setting. Then look up the appropriate setup
case in the second or third column based on your phone system. Step-by-step
instructions are included for each case in the sections that follow.
If you have answered all the questions in the previous section and have none of the
described equipment or services, choose "None" from the first column in the table.

NOTE:

If your home or office setup is not described in this section, set up the HP All-

in-One as you would a regular analog phone. Make sure you use the phone cord
supplied in the box to connect one end to your telephone wall jack and the other end
to the port labeled 1-LINE on the back of the HP All-in-One. If you use another phone
cord, you might experience problems sending and receiving faxes.

Other equipment/services
sharing your fax line

Recommended fax setup for
parallel-type phone systems

Recommended fax setup for
serial-type phone systems

None
(You answered No to all
questions.)

Case A: Separate fax line (no
voice calls received)

DSL service
(You answered Yes to question
1 only.)

Case B: Set up the HP All-in-
One with DSL

PBX or ISDN system
(You answered Yes to question
2 only.)

Case C: Set up the HP All-in-
One with a PBX phone system
or an ISDN line

Distinctive ring service
(You answered Yes to question
3 only.)

Case D: Fax with a distinctive
ring service on the same line

Voice calls
(You answered Yes to question
4 only.)