HP Officejet J5740 All-in-One Printer - Manual (Page 24)

To set redial options from the control panel
1. Press Setup.
2. Do one of the following:
To change the Busy Redial setting
▲ Press 5, and then press 2.
This selects Advanced Fax Setup and then selects Busy Redial.
To change the No Answer Redial setting
▲ Press 5, and then press 3.
This selects Advanced Fax Setup and then selects No Answer Redial.
3. Press to select Redial or No Redial.
4. Press OK.
Adjust the volume
The HP All-in-One provides three levels for adjusting the ring and speaker volume. The
ring volume is the volume of the phone rings. The speaker volume is the level of
everything else, such as the dial tones, fax tones, and button press beeps. The default
setting is Soft.
To adjust the volume from the control panel
1. Press Setup.
2. Press 4, and then press 5 again.
This selects Basic Fax Setup and then selects Ring and Beep Volume.
3. Press to select one of the options: Soft, Loud, or Off.
NOTE: The beeps you hear when pressing buttons maintain the same volume
whether you choose Loud or Soft. These two options only affect ring, dial, and
other tones you hear when faxing. If you choose Off, however, the sounds of
button presses are also turned off.
If you select Off, you will not hear a dial tone, fax tones, or incoming ring tones.
With the Ring and Beep Volume set to Off, you cannot send a fax using monitor
dialing, such as when using a calling card to send a fax.
4. Press OK.
Related topics
Send a fax using monitor dialing
Set tone or pulse dialing
You can set the dial mode for the HP All-in-One to either tone dialing or pulse dialing.
Most telephone systems work with either type of dialing. If your telephone system does
not require pulse dialing, HP recommends using tone dialing. If you have a public
telephone system or a private branch exchange (PBX) system, you might need to
select Pulse Dialing. Contact your local telephone company if you are unsure which
setting to use.
Chapter 4
22 Finish setting up the HP All-in-One