HP Deskjet F4210 All-in-One Printer - Manual (Page 104)

Solution 1: Check the print settings
Solution: Check the print settings.
• Check the paper type setting to make sure it matches the type of paper loaded in
the input tray.
• Check the quality setting. Use a higher quality setting to increase the amount of
ink used for printing.
For more information, see:
• “Set the paper type for printing” on page 33
• “Change the print speed or quality” on page 34
• “Print using Maximum dpi” on page 41
Cause: The paper type or print quality settings were incorrectly.
If this did not solve the issue, try the next solution.
Solution 2: Check the paper type
Solution: HP recommends that you use HP Advanced Papers or any other paper
type that is appropriate for the product.
Always make sure the paper you are printing on is flat. For best results when printing
images, use HP Advanced Photo Paper.
Store photo media in its original packaging inside a resealable plastic bag on a flat
surface in a cool, dry place. When you are ready to print, remove only the paper you
plan to use immediately. When you have finished printing, return any unused photo
paper to the plastic bag. This will prevent the photo paper from curling.
NOTE: There is no problem with the ink supplies and replacing the print
cartridges is unnecessary.
For more information, see:
• “Recommended papers for printing and copying” on page 22
• “Information on paper” on page 88
Cause: The wrong kind of paper was loaded in the input tray.
If this did not solve the issue, try the next solution.
Solution 3: If you are making a copy, place a protective sheet on the glass
Solution: If you are making a copy, try placing one or more clear plastic sheet
protectors directly on the glass, and then place the original print side down on top of
the sheet protectors.
Cause: The quality of the original was poor.
If this did not solve the issue, try the next solution.
Chapter 12
102 Troubleshooting
T
roub
les
hoot
ing