Solution 2: clear the print queue, Solution 3: disconnect and reconnect the usb cable – HP Deskjet F4210 All-in-One Printer User Manual
Page 151
3.
Make sure the test patterns show a complete grid and the thick color lines are
complete.
•
If more than a few lines in a pattern are broken, this might indicate a problem
with the nozzles. You might need to clean the print cartridges.
•
If the black line is missing, faded, streaked, or shows lines, this might indicate
a problem with the black print cartridge in the right slot.
•
If any of the color lines are missing, faded, streaked, or show lines, this might
indicate a problem with the tri-color print cartridge in the left slot.
If the self-test report fails to print, make sure you set up the product properly. See the
Setup Guide that came with the product for information about setting it up.
Cause: The product was not set up properly.
If this did not solve the issue, try the next solution.
Solution 2: Clear the print queue
Solution: Restart your computer to clear the print queue.
To clear the print queue
1.
Restart your computer.
2.
After the computer has restarted, check the print queue.
a. Depending upon your operating system, do one of the following:
•
Windows Vista: On the Windows taskbar, click Start, click Control
Panel, and then click Printers.
•
Windows XP: On the Windows taskbar, click Start, click Control Panel,
and then click Printers and Faxes.
•
Windows 2000: On the Windows taskbar, click Start, point to Settings,
and then click Printers.
b. Double-click the icon for your product to open the print queue.
If there are no print jobs pending, the issue might have been resolved.
3.
Try to print again.
Cause: The computer needed to be restarted to clear the print queue.
If this did not solve the issue, try the next solution.
Solution 3: Disconnect and reconnect the USB cable
Solution: Disconnect the USB cable from the computer and product, and then
reconnect it.
To disconnect and reconnect the USB cable
1.
Disconnect the USB cable from the product.
2.
Disconnect the USB cable from the computer.
3.
Leave the USB cable disconnected for 5-6 seconds.
Errors
149
Trou
bles
ho
ot
ing