HP Photosmart D7560 Printer - Manual (Page 176)

Solution 2: Remove objects blocking the path
Solution: Remove any objects, such as paper, that are blocking the print carriage
path. Then reset the product.
To clear the print carriage
1. Leave the product on and then disconnect the power cord and the USB cable
from the back of the product.
CAUTION: Make sure the product is on before disconnecting the power
cord. Failure to disconnect the power cord from the rear of the product can
cause damage when removing jammed paper. Do not reconnect the power
cord and USB cable until instructed to later.
2. Open the ink cartridge access door by lifting from the front center of the product,
until the door locks into place.
3. Make note of where the print carriage is stuck and look for jammed paper.
A paper jam can cause the error message and the print carriage to stall.
CAUTION: Do not use any tools or other devices to remove jammed paper.
Always use caution when removing jammed paper from inside the product.
If the print carriage is stuck on the left side
a. Check for any paper or object that may be restricting the print carriage.
b. Move print carriage all the way to the right side.
c. Check the paper path all the way to the left side and remove any paper still
in the product.
If the print carriage is stuck in the middle
a. Check for any paper or object that may be restricting the print carriage.
b. Move print carriage all the way to the left side.
c. Check the paper path all the way to the right side and remove any paper still
in the product.
d. Move print carriage all the way to the right side.
e. Check the paper path all the way to the left side and remove any paper still
in the product.
Errors 173
Trou
bles
ho
ot
ing