GE ZGP304LRSS - Manual (Page 30)

30
Care and Cleaning
Professional All-Gas Range
Oven racks
Low profile
oven rack
The racks may remain in the oven during the self-
cleaning cycle without being damaged.
Periodically, after several self-clean cycles, the
oven racks may need to be lubricated using
the Graphite Lubrication shipped with your range.
To order additional Graphite Lubrication, call
our National Parts Center at and
reference :%7.
 Remove rack from the oven. See the Full
extension oven racks section.
 Fully extend the rack on a table or countertop.
Newspaper may be placed underneath the
rack for easy cleanup.
 If there is debris in the slide tracks, wipe it
away using a paper towel. NOTE: Any graphite
lubricant wiped away must be replaced.
 Shake the graphite lubricant before opening it.
Starting with left slide mechanism of the rack,
place four (4) small drops of lubricant on the
two (2) bottom tracks of the slide close to the
bearing carriers.
 Repeat for the right slide mechanism of
the rack.
 Open and close the rack several times to
distribute the lubricant.
 Replace the cap on the lubricant and shake
it again. Turn the rack over and repeat steps 3,
4, 5 and 6.
 Close the rack, turn rack right-side-up and
place in the oven. See the Full extension oven
racks section.
 Repeat above steps for each rack.
127( Do not use a cooking spray or other
lubricant sprays on the slides.
Left side
Rack right-side-up
Rack right-
side-up
Right side
The gray porcelain-coated low profile rack may
remain in the oven during the self-cleaning cycle
without being damaged. It may also be cleaned
using a mild abrasive cleanser. After cleaning,
rinse the rack with clean water and dry with a
clean cloth.
Periodically and after clean cycles, the low profile
rack may need to be lubricated to aid sliding.
Wipe the rack edges or oven rack supports with
the Graphite Lubrication shipped with your range
or vegetable oil.
To order additional Graphite Lubrication, call
our National Parts Center at  and
reference :%7.