GE ZGP304LRSS - Manual (Page 35)

Spark
igniter and
electrodes
The electrode of the electronic ignition system is
positioned at the rear of the burner base. When
cleaning the cooktop, be careful not to snag the
igniter with your cleaning cloth. Damage to the
igniter could occur.
Be careful not to push in a control knob while
cleaning. It could cause the igniter to spark.
Make sure that the white ceramic igniters on
the cooktop are dry and clean. Clean the metal
portion of the electrode with a soft cloth or
emery board.
'RQRWDWWHPSWWRUHPRYHWKHHOHFWURGHIURP
WKHFRRNWRS
Clean this metal part
with an emery board.
Do not clean this
white ceramic part
with an emery board.
Care and Cleaning
Professional All-Gas Range
Burner
grates
The enameled cast-iron burner grates should be
cleaned regularly.
You must put the grates on the self-clean oven
rack during the self-clean cycle. DO NOT put the
grate on the oven floor during a self-clean cycle.
DO NOT put the frame inside the oven during a
self-clean cycle. Only the grate can withstand the
heat of the self-clean cycle. The frames may be
cleaned by hand or in the dishwasher.
Wash them in hot soapy water, rinse, and dry
thoroughly.
Although they are durable, the grates will
gradually lose their shine, regardless of the
best care you can give them. This is due to their
continual exposure to high temperatures.
Do not operate a burner for an extended period
of time without cookware on the grate. The finish
on the grate may chip without cookware to
absorb the heat.
For stability, the frames have rubber pads on
each corner. During cleaning and use, be careful
not to damage or snag rubber pads.
Grates
35
Frame
Pads