JKS 9901 User Manual
Installation instructions, Welcome, Tools required
JKS part number
JKS DESCRIPTION Installation
Page 1
INSTALLATION
INSTRUCTIONS
Product: B1 Body Lift
Part Number: JKS9901
Applications: CJ8, 1978-82
Welcome
Congratulations on purchasing a new B1 Body Lift from
JKS® Manufacturing. We are committed to providing you
with the best products available and your satisfaction is our
first priority.
We hope you enjoy your JKS® purchase and are here to
help if you still have questions after reviewing this safety
information and instructions. Contact us online at www.
jksmfg.com or by phone at 877-533-7557.
Tools Required
Metric/Standard Socket Wrench Set
Torque Wrench
Tape Measure
Medium Strength Threadlocker
Hydraulic Floor Jack
Sturdy Block of Wood (to protect body)
Center Punch and Hammer
3/8” Drill Bit
1/8” Drill Bit or Torch * (for removing plastic rivets
in steering slip shaft)
Reciprocating Saw or Die Grinder with Cut-Off Wheel *
(for trimming fan shroud)
Wire Brush *
Factory Service Manual (recommended)
* Asterisk denotes tools that are not required for some applica-
tions. Thoroughly read instructions first to determine which tools
will be required for your application.
CAUTION
Always Wear Protective Gear
Safety glasses and protective gloves are required.
Parts
Description
QTY
A
Dura-Thane™ Body Puck
13
B
3/8” x 3-1/2” Bolt
8
C
3/8” x 4” Bolt
2
D
3/8” Flat Washer
10
E
7/16” x 4” Bolt
3
F
7/16” Flat Washer
3
NOTICE
One Side At A Time
Body lift must be installed on one side of vehicle at a time.
517-278-1226 • [email protected] • www.jksmfg.com
491 W. Garfield Avenue, Coldwater, MI 49036