JKS 2710 - Manual

JKS ACOS Pro ™ Installation PN 2710 Page 1 of 5
Installation
Instructions
Product: ACOS Pro™
Part Number: PN 2710
Application: Jeep Wrangler JK, 2007+ (front only)
Welcome
CONGRATULATIONS on your purchase
of a new JKS ACOS Pro
™ system! At JKS
Manufacturing, we are committed to providing
you with the best products available and your
satisfaction is our first priority.
PLEASE READ these Installation Instructions
carefully, and save them for future reference,
as they contain important installation and
maintenance information.
Before You Begin…
1. Familiarize yourself with the supplied parts
as illustrated in the column to the far right.
2. Thoroughly read all procedures to ensure
you have the tools and experience
necessary to complete this installation.
3. If you are not completely comfortable with
any of the procedures described on the
following pages, do not attempt this
installation. Contact the JKS Technical
Department at (308) 762-6949 to locate a
qualified installation specialist in your area.
Important
MOST VEHICLES REQUIRE additional parts
or modifications to accommodate the
immediate increase in ride height provided by
the ACOS Pro
™ system.
DO NOT EXCEED maximum range of
adjustment
– see illustration on page 3.
NOT COMPATIBLE with Rancho, TrailMaster,
Rough Country or Fabtech coil springs.
INSTALLATION of this product is not
reversible and should only be performed by an
experienced mechanic or fabricator.
Tools Required
 Hydraulic Floor Jack and Jack Stands
 Metric/Standard Socket Wrench Set
 1/4” Allen Wrench
 Die Grinder with Cut-Off Wheel
(or reciprocating saw)
 File or Deburring Tool
 Emory Cloth (or similar paint stripping tool)
 Rubber or Plastic Mallet *
 Tape Measure
 Spray Lubricant (WD-40 or similar)
 Anti-Seize Lubricant
 Medium Strength Threadlocker
 Satin Black Spray Paint
 Welding Equipment
 Band Saw (or equivalent) *
 16TPI Thread Restoring File (or equivalent) *
 Coil Spring Compressor *
 Factory Service Manual (recommended)
* Asterisk denotes tools that are not required for some
applications. Thoroughly read instructions first to
determine which tools will be required for your
application.
Parts
DESCRIPTION QTY
A Threaded Tube 2
B Adjuster Ring 2
C 5/16” x 1-1/4” Cap Bolt 2
D Isolator Pad 2
E Bump Shock Adapter 2
F Bump Shock Nut 2
G Bump Shock Assembly 2