JKS 6155 - Manual

JKS6155 JKS Adjustable Control Arm Installation Page 1
INSTALLATION
INSTRUCTIONS
Product: Adjustable Control Arms
Part Number: JKS6155
Applications: Wrangler JK, 2007+ (rear only)
Welcome
CONGRATULATIONS on purchasing a set of new Adjust-
able Control Arms from JKS Manufacturing. We are com-
mitted to providing you with the best products available and
your satisfaction is our first priority.
PLEASE READ these Installation Instructions carefully,
and save them for future reference, as they contain impor-
tant installation and maintenance information.
Important
SUSPENSION COMPONENTS THAT HAVE RUBBER
BUSHINGS must be tightened with vehicle on level
ground and at normal ride height. The springs must
be supporting weight of vehicle when the hardware is
torqued.
RUBBER BUSHINGS MUST NEVER BE LUBRICATED,
as doing so will impair performance and longevity.
COMPATIBLE WITH original 4-link suspension con-
figuration and vehicle ride height up to 6.0”.
REFER TO FACTORY SERVICE MANUAL for informa-
tion and procedures not covered in these instructions.
Tools Required
 Hydraulic Floor Jack and Jack Stands
 Metric/Standard Socket Wrench Set
 Torque Wrench
 Tape Measure
 Anti-Seize Lubricant
 Hand-Pump Grease Gun
 Moisture Resistant Marine Style Grease
 Heavy Duty Ratchet Strap *
 Factory Service Manual (recommended)
* Asterisk denotes tools that are not required for some applica-
tions. Thoroughly read instructions first to determine which tools
will be required for your application.
ATTENTION INSTALLER
Install Adjustable Control Arms ONE AT A TIME for easi-
est alignment of mounting hardware.
Installation
‰ 1. REMOVE ORIGINAL LOWER
SUSPENSION ARM
 Raise and support the vehicle chassis with jack
stands positioned in front of the rear lower suspen-
sion arm brackets.
 Raise the axle housing back into position and sup-
port with a hydraulic jack. HINT: The axle housing
should be evenly supported and the suspension
at normal ride height. Do not attempt removal or
installation with the suspension extended, or the
axle drooped, as this will place tension on suspen-
sion arm mounting hardware.
517-278-1226 • [email protected] • www.jksmfg.com
491 W. Garfield Avenue, Coldwater, MI 49036