JKS 9902 User Manual
Installation instructions, Welcome, Important
JKS9902
JKS Body Lift Installation
Page 1
INSTALLATION
INSTRUCTIONS
Product: B1 Body Lift
Part Number: JKS9902
Applications: CJ5 & CJ7, 1976-86
Welcome
Congratulations on purchasing a new B1 Body Lift from
JKS® Manufacturing. We are committed to providing you
with the best products available and your satisfaction is our
first priority.
We hope you enjoy your JKS® purchase and are here to
help if you still have questions after reviewing this safety
information and instructions. Contact us online at www.
jksmfg.com or by phone at 877-533-7557.
Important
NOT COMPATIBLE WITH aftermarket swaybars. Install
product with Original Equipment swaybar only.
SOME VEHICLES MAY REQUIRE extended front brake
hoses or other modifications to compensate for ad-
ditional suspension travel.
NEVER DISCONNECT swaybar when operating vehicle
on public roads.
WHEN DISCONNECTED, swaybar must be secured to
prevent interference with other suspension compo-
nents or axle.
Tools Required
Metric/Standard Socket Wrench Set
Torque Wrench
Tape Measure
Medium Strength Threadlocker
Hydraulic Floor Jack
Sturdy Block of Wood (to protect body)
Center Punch and Hammer
3/8” Drill Bit
1/8” Drill Bit or Torch * (for removing plastic rivets
in steering slip shaft)
Reciprocating Saw or Die Grinder with Cut-Off Wheel *
(for trimming fan shroud)
Wire Brush *
Factory Service Manual (recommended)
* Asterisk denotes tools that are not required for some applica-
tions. Thoroughly read instructions first to determine which tools
will be required for your application.
CAUTION
Always Wear Protective Gear
Safety glasses and protective gloves are required.
Parts
Description
QTY
A
Dura-Thane™ Body Puck
11
B
3/8” x 3-1/2” Bolt
6
C
3/8” x 4” Bolt
2
D
3/8” Flat Washer
8
E
7/16” x 4” Bolt
3
F
7/16” Flat Washer
3
517-278-1226 • [email protected] • www.jksmfg.com
491 W. Garfield Avenue, Coldwater, MI 49036