JKS BSE201 - Manual

JKSBSE201 JKS Hydraulic Bump Shocks Installation Page 1
INSTALLATION
INSTRUCTIONS
Product: Hydraulic Bump Shocks
Part Number: JKSBSE201
Applications: Wrangler JK, 2007+ (front only)
Welcome
CONGRATULATIONS on purchasing a set of new Hydrau-
lic BumpShocks from JKS Manufacturing! We are commit-
ted to providing you with the best products available and
your satisfaction is our first priority.
PLEASE READ these Installation Instructions carefully,
and save them for future reference, as they contain impor-
tant installation and maintenance information.
Important
DO NOT EXCEED maximum range of bump shock ad-
justment – see illustration on page 3.
INSTALLATION of this product is not reversible and
should only be performed by an experienced mechan-
ic or fabricator.
Tools Required
 Hydraulic Floor Jack and Jack Stands
 Metric/Standard Socket Wrench Set
 Spanner or Strap Wrench *
(or similar tool for tightening Bump Shock Nut)
 Die Grinder with Cut-Off Wheel (or reciprocating saw)
 File or Deburring Tool
 Emory Cloth (or similar paint stripping tool)
 Tape Measure
 Felt Tip Marker (or similar marking tool)
 Small Clamping Tool *
 Welding Equipment
 Drill with 3/8” Bit
 Coil Spring Compressor *
 Spray Lubricant (WD-40 or equivalent)
 Anti-Seize Lubricant
 Satin Black Spray Paint
 Factory Service Manual (recommended)
* Asterisk denotes tools that are not required for some applica-
tions. Thoroughly read instructions first to determine which tools
will be required for your application.
Parts
Description QTY QTY
A Bump Shock Assembly RFC/BS02 2
B Bump Shock Nut RFC/SN50 2
C Jounce Adapter 03154 2
877-533-7557 • [email protected] • www.jksmfg.com
491 W. Garfield Avenue, Coldwater, MI 49036