JKS 6100 User Manual

Installation instructions, Welcome, Tools required

Advertising
background image

JKS6100

JKS Adjustable Control Arm Installation

Page 1

INSTALLATION

INSTRUCTIONS

Product: Adjustable Lower Control Arms
Part Number: JKS6100

Welcome

CONGRATULATIONS on purchasing a set of new

Adjustable Control Arms from JKS Manufacturing. We

are committed to providing you with the best products

available and your satisfaction is our first priority.
PLEASE READ these Installation Instructions careful-

ly, and save them for future reference, as they contain

important installation and maintenance information.

Tools Required



Metric/Standard Socket Wrench Set



Torque Wrench



Tape Measure



Anti-Seize Lubricant



Hydraulic Floor Jack & Jack Stands



Heavy Duty Ratchet Strap *



Factory Service Manual (recommended)

* Asterisk denotes tools that are not required for some applica-

tions. Thoroughly read instructions first to determine which tools

will be required for your application.

Important

SUSPENSION COMPONENTS THAT HAVE RUB-

BER BUSHINGS must be tightened with vehicle

on level ground and at normal ride height. The

springs must be supporting the weight of the

vehicle when the hardware is torqued; or else ride

comfort could be affected and premature bushing

wear may occur.
RUBBER BUSHINGS MUST NEVER BE LUBRI-

CATED, as doing so will impair performance and

longevity.
COMPATIBLE WITH original 4-link suspension

configuration and vehicle ride height up to 6.0”.
REFER TO FACTORY SERVICE MANUAL for

information and procedures not covered in these

instructions.

ATTENTION INSTALLER

Install Adjustable Control Arms ONE AT A TIME

for easiest alignment of mounting hardware.

Installation

‰

1. REMOVE ORIGINAL LOWER

SUSPENSION ARM



Raise and support the vehicle chassis with jack

stands.

Â

FRONT INSTALLATION – Position behind

front lower suspension arm brackets.

Â

REAR INSTALLATION – Position in front of

rear lower suspension arm brackets.

517-278-1226 • [email protected] • www.jksmfg.com

491 W. Garfield Avenue, Coldwater, MI 49036

Applications: Wrangler TJ, 1997-06 (front or rear)

Gr. Cherokee ZJ, 1993-98 (front or rear)

Grand Cherokee WJ, 1999-04 (front only)

Cherokee XJ, 1984-01 (front only)

Comanche MJ, 1986-92 (front only)

Advertising