Kenwood KDC-W9537U - Manual (Page 38)

38 | English
9 Exit Security Code mode
Press the [FNC] button.
Resetting the Security Code function when the
audio unit is first used after removed from the
battery power source or the Reset button is
pressed
1 Turn the power ON.
2 Do the step 4 through 7 step operation, and
reenter the security code.
"Approved" is displayed.
Now, you can use the unit.
⁄
• If an incorrect code is entered, "Waiting" is displayed, and
the input prohibition periods shown in the table below
is generated.
After the input prohibition time lapses, "SECURITY" is
displayed, and you can reenter the code.
Number of times the
incorrect code was input Input prohibited time
1 —
2 5 minutes
3 1 hour
4 24 hours
In Standby mode
Source Select Mode
Setting up the Source Select mode.
Display Setting
"SRC Select : 1" Displays source icons for your choice.
"SRC Select : 2" Allows you to select sources one after another.
In Standby mode
Security Code
Activating the Security Code disables the usage
of audio unit by someone else. Once the Security
Code is activated, the entry of authorized Security
Code is required to turn on the audio unit when it is
removed from the vehicle. Indication of this Security
Code activation prevents your precious audio unit
from stealing.
⁄
• When you activate the Security Code function, it cannot be
released.
Note, your Security Code is the 4 digit number entered in
your "Car Audio Passport" in this package.
1 Enter Standby
Press the [SRC] button.
Select the "STANDBY" display.
Refer to <Selecting the Source> (page 8).
2 Enter Menu mode
Using the Control knob, select "MENU".
For the operation method, refer to <Function
Control mode> (page 11).
"Security Set" is displayed.
3 Enter Security Code mode
Press the Control knob for at least 1 second.
When "Enter" is displayed, "SECURITY SET" is also
displayed.
4 Select the digits to enter
Push the Control knob towards right or left.
5 Select the Security Code numbers
Turn the Control knob or push it towards up or
down.
6 Repeat steps 4 and 5, and complete the
Security Code.
7 Confirm the Security Code
Press the Control knob for at least 3 seconds.
When "Re-Enter" is displayed, "SECURITY SET" is also
displayed.
8 Do the step 4 through 7 step operation, and
reenter the security code.
"Approved" is displayed.
The Security Code function activates.
⁄
• If you enter a Code different from your Security Code,
you have to start over from step 4.
Menu system
B64-3773-00_00_E_English.indd 38 B64-3773-00_00_E_English.indd 38 07.5.10 5:18:41 PM 07.5.10 5:18:41 PM