Kenwood KDC-W9537U - Manual (Page 40)

40 | English
Display Illumination Control
This function turns off the display when you
perform no operation for 5 seconds. This function is
effective when you are driving at night.
Display Setting
"Display : ON" Keeps the display on.
"Display : OFF" Turns off the display when you perform no
operation for 5 seconds.
⁄
• Set the Display Illumination Control when the
<Demonstration mode Setting> (page 46) is set to OFF.
• When the display is off, pressing any key will turn on the
display.
• When the display is off, you cannot perform any
operation except for the following:
• Volume
• Attenuator
• Selecting the source
• Ejecting the disc
• Turning off the power
• USB remove mode
• During function control, such as the Menu System, the
display stays on.
In Standby mode
Dimmer
Dimming this unit’s display automatically when the
vehicle light switch is turned ON.
Display Setting
"Dimmer : ON" The display dims.
"Dimmer : OFF" The display doesn’t dim.
In Standby mode
Contrast Adjustment
Adjusting the display contrast.
Display and Setting
"Contrast : 1"
…
"Contrast : 4" (Original setting)
In Standby mode
Display-reversing Setting
If no operation is performed for a predetermined
period of time, switching between negative and
positive display modes takes place automatically.
Display-reversing maintains the initial brightness of
the display for a long period of time.
Display Setting
"Display N/P : Auto" Auto reverse display
"Display N/P : POSI" Positive display only
⁄
• Switching between negative and positive display may
not take place depending on the displayed mode.
Menu system
In Standby mode
Synchronize Clock
Synchronizing the RDS station time data and this
unit’s clock.
Display Setting
"SYNC : ON" Synchronizes the time.
"SYNC : OFF" Adjust the time manually.
⁄
• It takes 3 to 4 minutes to synchronize the clock.
In Standby mode
DSI (Disabled System Indicator)
A red indicator will blink on the unit after the
faceplate is removed, warning potential thieves.
Display Setting
"DSI : ON" LED flashes.
"DSI : OFF" LED OFF.
B64-3773-00_00_E_English.indd 40 B64-3773-00_00_E_English.indd 40 07.5.10 5:18:42 PM 07.5.10 5:18:42 PM