Kenwood KDC-W9537U - Manual (Page 9)

English | 9
Volume
Increasing Volume
Turn the [VOL] knob clockwise.
Decreasing Volume
Turn the [VOL] knob counterclockwise.
Attenuator
Turning the volume down quickly.
Press the [ATT] button.
Each time you press the button, the Attenuator
turns ON and OFF.
When the Attenuator is ON, the "ATT" indicator
blinks.
Audio Control
1 Select the source to adjust
Press the [SRC] button.
Refer to <Selecting the Source> (page 8).
2 Enter Audio Control mode
Press the [VOL] knob.
3 Select the Audio item to adjust
Press the [VOL] knob.
Each time you press the knob, the item to be
adjusted alternates between the items shown in
the table below.
4 Adjust the Audio item
Turn the [VOL] knob.
Adjustment Item Display Range
Rear Volume "REAR VOLUME" 0 — 35
Subwoofer level "SUBWOOFER LEVEL" –15 — +15
Balance "BALANCE" Left 15 — Right 15
Fader "FADER" Rear 15 — Front 15
Exit Audio Control mode (Volume control mode)
5 Exit Audio Control mode
Press any button.
Press a button other than the [VOL] knob, [
0] and
[ATT] button.
Audio Setup
Setting the Sound system, such as Volume offset
and Dual Zone.
1 Select the source to adjust
Press the [SRC] button.
Refer to <Selecting the Source> (page 8).
2 Enter Audio Setup mode
Press the [VOL] knob for at least 1 second.
3 Select the Audio Setup item to adjust
Press the [VOL] knob.
Each time you press the knob, the item to be
adjusted alternates between the items shown in
the table below.
4 Setup the Audio item
Turn the [VOL] knob.
Adjustment Item Display Range
Volume offset "VOLUME OFFSET" –8 — ±0 (AUX: -8— +8)
Dual Zone System "2 ZONE" ON/OFF
⁄
• Volume offset: Sets each source’s volume as a difference
from the basic volume.
• Dual Zone System
Main source and sub source (Auxiliary input) output
Front channel and Rear channel separately.
- Set up the channel of sub source by <Dual Zone
System Setting> (page 41).
- Select Main source by [SRC] button.
- Adjust the volume of Front channel by [VOL] knob.
- Adjust the volume of Rear channel by <Audio Control>
(page 9).
- The DSP Control will be disabled.
• You can use the Dual Zone System only when you have
set the rear speaker to any mode other than "None" in
the <Sound Management system> (page 12).
5 Exit Audio Setup mode
Press the [VOL] knob for at least 1 second.
B64-3773-00_00_E_English.indd 9 B64-3773-00_00_E_English.indd 9 07.5.10 5:18:23 PM 07.5.10 5:18:23 PM