MagTek IntelliStripe65 99875161 - Manual (Page 25)

Section 4. Magnetic Stripe Application
19
Card Encode Type definition:
Value Encode Type Description
0 ISO/ABA ISO/ABA encode format
1 AAMVA AAMVA encode format
2 CADL CADL encode format. Note that some versions of this reader
can only read track 2 for this format. They can not read tracks 1
and 3. However, this format is obsolete. There should no
longer be any cards in circulation that use this format. California
is now using the AAMVA format.
3 Blank The card is blank
4 Other The card has a non-standard encode format. For example,
ISO/ABA track 1 format on track 2.
5 Undetermined The card encode type could not be determined because no
tracks could be decoded.
6 None No decode has occurred. This type occurs if no magnetic stripe
data has been acquired since the data has been cleared or
since the device was powered on.
7 JIS Type 2 JIS X 6302 Type 2 encode format
Response Message Result Codes:
Success = 00 (Hex)
The command completed successfully.
Example Request:
Field MTYP APPL CMND RC
Byte 1 2 3 4
Value (Hex) 00 01 81 00
Example Response:
Field MTYP APPL CMND RC DCD STAT ENCD TYP
Byte 1 2 3 4 5 6
Value (Hex) 40 01 81 00 00 00
Field TK1 LEN TK2 LEN TK3 LEN TK123 DATA
Byte 7 8 9 10 - 153
Value (Hex) 37 22 37 Track1 Track2 Track3
GET TRACK DECODE DATA COMMAND
Command ID: 82 (Hex)
Description:
This command is used to get decoded information related to a magnetic stripe read for a single
track. This command always returns data from the most current magnetic stripe data acquisition.
This command is used to get decode status, card encode type and decoded card data for a given
track. The track of decoded data starts with a start sentinel and ends with an end sentinel and is
converted to ASCII format. The ASCII representation of the start and end sentinels vary
depending on the encode format.