MagTek IntelliStripe65 99875161 - Manual (Page 27)

Section 4. Magnetic Stripe Application
21
Response Message Result Codes:
Success = 00 (Hex)
The command completed successfully.
Bad Parameter = 06 (Hex)
The command failed due to a bad parameter in the request message data field
Example Request:
Field MTYP APPL CMND RC TRACK
Byte 1 2 3 4 5
Value (Hex) 00 01 82 00 02
Example Response:
Field MTYP APPL CMND RC TRACK DCD STAT
Byte 1 2 3 4 5 6
Value (Hex) 40 01 82 00 02 00
Field ENCD TYP TK DATA
Byte 7 8 - 41
Value (Hex) 00 Track2
GET MAGNEPRINT DATA COMMAND
Command ID: 86 (Hex)
Description:
This command is used to get MagnePrint™ information for the most recently read card.
Note 1: This command available only on units with MagnePrint feature.
Note2: MagnePrint™ data obtained from a read-on-insert swipe (see MSR Direction Property in
the Transport section) will not correlate as well as data obtained from a read on withdrawal.
We recommend setting the MSR Direction Property to withdrawal when using the MagnePrint™
data.
Request Message Data: None