MagTek IntelliStripe65 99875161 - Manual (Page 39)

Section 5. Smart Card Application
33
EMV TD2 Rules 2C Boolean 1 FALSE* Get/Set This property indicates whether the Power Up sequence should use EMV
rules for screening TD2. If the property is TRUE, the EMV rules are used
(protocol T=14 may be designated, though it will not be used). If the
property is FALSE, TD2 with T=14 will cause an Error or Warning
depending on the contents of the Error and Warning Condition
Templates. This property is TRUE in the EMV Mode.
Parity Error Repeat
Count 2D Dword 1 5* Get/Set In T=0 there is a mechanism for requesting retransmission of a character
with incorrect parity. This property sets the total number of
receptions/transmissions allowed for a single character in T=0.
Operating Mode 2E Binary 1 0 Get/Set This property defines the Operating Mode for microprocessor cards.
Changing this changes numerous other properties. This property
should only be changed when no cards are currently activated.
Values are as follows:
0 – ISO 7816-3(1997) Mode
1 – EMV 4.1 Mode
Trying to set this property to any other value will get a RC of failure.
Setting this property sets the Operating Mode of all connectors in the
device.
PPS Delay 30 Dword 4 2 Get/Set This property defines the delay between receiving an ATR from a card
and transmitting a PPS request to a card. This delay is in 10ms units. So
the default value of 2 is equivalent to 20ms. Valid values for this delay
are 0 – 254 (0 – 2540ms).
Microprocessor Card Operating Properties, used to monitor Microprocessor Card operations. Settings of these properties only apply to the current
card session.
Name ID
(Hex)
Type Length Reset
Value Get/Set Description
Protocol 38 Binary 1 N/A Get This property gives the protocol number in use for the current card
session.
Proposed Protocol 39 Binary 1 N/A Get This property gives the protocol number the card proposed for use
pending a PPS sequence.
Speed 3A Dword 2 N/A Get This property gives the speed (in clocks/ETU) for the current card
session.
Proposed Speed 3B Dword 2 N/A Get This property gives the speed (in clocks/ETU) the card proposed for use
pending a PPS sequence.
Proposed FI/DI 3C Binary 1 N/A Get This property gives the FI and DI from TA1 which were used to calculate
the Proposed Speed property.