MagTek IntelliStripe65 99875161 - Manual (Page 61)

Section 7. Transport Application
55
Example Set Property Request:
Field MTYP APPL CMND RC PTYP PID
Byte 1 2 3 4 5 6
Value (Hex) 00 82 01 00 01 02
Field PVAL
Byte 7 - 10
Value (Hex) 02 00 00 00 (Card Seated)
Example Set Property Response:
Field MTYP APPL CMND RC
Byte 1 2 3 4
Value (Hex) 40 82 01 00
MSR ARM STATE PROPERTY
Property ID: 03 (Hex)
Property Type: Dword
Power Up/Reset Value: 0 (Unarmed)
Get/Set/Save support: All
Description:
This property is used control the magnetic stripe read arm state. This state must be set properly
in order to read magnetic stripe cards. This property should be used with the MSR Direction
property.
Values:
Value State Description
0 Unarmed A read will not occur when a card is swiped.
1 Armed to Read
Once A read will occur on the next card swipe. The read direction
depends on how the MSR Direction Property is set. Once the
read occurs, the MSR Arm State Property will change to
Unarmed State. After which a read will no longer occur when
a card is swiped until the host re-arms the reader by changing
the MSR Arm State.
2 Armed to Read
Multiple Times A read will occur on every card swipe. The read direction
depends on how the MSR Direction Property is set. If the
read data is not sent to the host by the time the next read
occurs, it will be lost.