Campbell Scientific RF401-series and RF430-series Spread Spectrum Data Radios/Modems - Manual (Page 54)

Appendix B. Advanced Setup Menu
(4) AT Command Mode Timeout
(units of 100 msec; 1 – 32767)
iv) Radio Diagnostics
Number of Retry Failures:
Received Signal Strength:
v) Radio Retry Settings
(1) Number of Retries
(0 – 255)
(2) Number of time slots for random retry
(units of 38 msec; 0 – 255)
(3) Number of bytes transmitted before delay
(1 – 65535)
(4) Sync Timer Setting;
(units of 100 msec; 0 – 255)
vi) Configure RF401 for Firmware Download
b) Interface Parameters
i) SDC Address (Not Active):
(7 or 8)
ii) RS-232 Auto Power Down Enable
0 => RS-232 always active to power RS-232 devices
1 => RS-232 TX automatically powers down when no activity for 30
sec
iii) RS-232 Parameters
(1) RS-232 Baud Rate:
0 => 1200
1 => 4800
2 => 9600
3 => 19.2k
4 => 38.4k
(2) RS-232 Parity:
0 => None
1 => Odd
2 => Even
(3) RS-232 Character Length:
0 => 8 bits
1 => 7 bits
(4) RS-232 Stop Bits:
0 => 1
1 => 2
2) Restore Defaults
3) Show All Current and Default Settings
4) Save All Parameters and Exit Setup
9) Exit Setup without Saving Parameters
This is a blank page.
B-2