Campbell Scientific RF401-series and RF430-series Spread Spectrum Data Radios/Modems - Manual (Page 69)

Appendix D. Setting Up RF401-to-CR206(X) Communications
D.3 Example Setup 2 - Router to CR206(X)
The following is a typical setup of an RF401 cabled to a router datalogger and
linked to a CR206(X) in a PakBus network.
CR206(X) Example Setup 2 (see FIGURE D-6)
1. Enter PakBus Address 1.
2. Select PakBus Aware for RF Protocol.
3. Select Hop Sequence 0.
4. Select Network (Address) 0.
5. The Radio Address is fixed at 0 when the RF Protocol is PakBus.
6. Select Power Mode 1 Sec with Long Header to economize station power.
FIGURE D-6. DevConfig Deployment panel for CR206(X) Example
Setup 2
D-7