Campbell Scientific RF401-series and RF430-series Spread Spectrum Data Radios/Modems - Manual (Page 77)

Appendix F. Non-PakBus Example Configurations
F.3 LoggerNet Configuration (Transparent Protocol)
There are two ways of configuring the Setup map for a point-to-point
‘network.’ You can represent the RF401s in the Setup map (as RF400s) or
simply leave them off. The simple map usually results in a quicker connection
and requires less typing.
(1) Point-to-point (not represented)
(a) Setup map:
ComPort_1
CR10X
(2) Point-to-point (represented)
(a) Setup map:
ComPort_1
RF400
RF400Remote
CR10X
(3) The station’s Maximum Baud Rate is typically 9600
(4) Extra Response Times are typically 0 s
In the case of point-to-multipoint, the RF401s are always represented in the
LoggerNet Setup map (as an RF400) so that LoggerNet can temporarily change
the base RF401’s Radio Address to communicate with one out of a group of
remote RF401s.
(1) Point-to-multipoint
(a) Setup map:
ComPort_1
RF400
RF400Remote_1
CR10X_1
RF400Remote_2
CR10X_2
RF400Remote_3
CR10X_3
(2) All RF400Remotes have the same Network Address but each
RF400Remote must have a unique Radio Address.
F-3