Allied Telesis AT-FS970M Series - Manual (Page 126)

Chapter 10: Setting Static Port Trunks
126
Figure 49. Add Static Trunk Page
5. Assign an ID number of a new static trunk in the Trunk ID field. The
range is 1 to 32.
6. Select the Load Balance Method. You can assign different load
distribution methods to different static trunks on the same switch.
Choose from the following:
 Src MAC— Source MAC address.
 Dst MAC— Destination MAC address.
 Src-Dst MAC— Source address and destination MAC address.
 Src IP— Source IP address.
 Dst IP— Destination IP address.
 Src-Dst IP— Source address and destination IP address.
7. Select a member port in the Device ID table by clicking a box that
indicates a port number. You can select multiple ports. A green check
mark indicates a port has been selected.
To deselect a port, click the box that indicates the port number.
8. Click Add.
A confirmation message is displayed.
9. Click SAVE to save your changes to the startup configuration file.