Allied Telesis AT-FS970M Series - Manual (Page 265)

AT-FS970M Series Version 2.3.1.0 Web Interface User’s Guide
265
Displaying the RIP Configuration
To check how the RIP is configured on the switch, do the following:
1. Hover the cursor over the Layer 3 tab.
The Layer 3 tab is displayed. See Figure 112.
Figure 112. Layer 3 Tab
2. From the Layer 3 tab drop-down menu, hover the cursor over RIP,
move the cursor to the right, and select Configuration from the RIP
drop-down menu.
The RIP configuration page is displayed. See Figure 113.
Figure 113. RIP Configuration Page
The following fields are displayed:
 VLAN— ID number of the VLAN. This VLAN interface receives and
sends RIP packets, and the network that the VLAN belongs to is
advertised through RIP.
 IP Interface— IP address that the VLAN interface is assigned to.