Allied Telesis AT-FS970M Series - Manual (Page 302)

Chapter 25: LLDP and LLDP-MED
302
Assigning LLDP Locations to a Port
Use a Civic, Coordinate, or ELIN location ID port location to assign to a
port. You must create these location IDs before you assign a port location
to a port. For instructions to create location IDs, see “Setting a Location
Entry for the LLDP-MED Location TLV” on page 294.
To set an LLDP port location, do the following:
1. Hover the cursor over the Discovery & Monitoring tab.
The Discovery & Monitoring tab is displayed. See Figure 122 on
page 284.
2. From the Discovery & Monitoring tab, hover over LLDP and then
select Port Locations on the right.
The LLDP Port Location page is displayed. See Figure 136.
Figure 136. LLDP Port Location Page
3. Click Edit next to the port that you want to modify.
The Modify LLDP Port Location page is displayed. See Figure 137 on
page 303.