Allied Telesis AT-FS970M Series - Manual (Page 267)

AT-FS970M Series Version 2.3.1.0 Web Interface User’s Guide
267
Enabling RIP on a VLAN Interface
To enable RIP and connect remote networks dynamically, you must
enable RIP on VLAN interfaces. When RIP is enabled on a VLAN
interface, the VLAN interface sends and receives RIP packets, and the
network where the VLAN belongs is advertised through RIP.
To enable RIP on a VLAN interface, you must add the VLAN to the RIP
routing process by performing the following procedure:
1. Hover the cursor over the Layer 3 tab.
The Layer 3 tab is displayed. See Figure 114.
Figure 114. Layer 3 Tab
2. From the Layer 3 tab drop-down menu, hover the cursor over RIP,
move the cursor to the right, and select Add RIP Interface from the
RIP drop-down menu.
The RIP Interface page is displayed. See Figure 115 on page 268.